Setech ST-EG100-E Guía de usuario descargar pdf (Pagina 9)

ST-EG100-E Installation and User Guide Installation

Chapter 2 Installation

2.1. Installing ST-EG100-E Ethernet Gateway

1. Remove power from the M1 Control board before making any connections.

2. Mount the ST-EG100-E to your existing Structured Wiring Box using the two (2)

ELK-SWG Circuit Board Guides, or the ELK-SWP3 Multipurpose Adapter Plate, or

four (4) ELK-SWNS1 Nylon Standoffs (see Figure 1). The ST-EG100-E should be

mounted within 10 feet of the M1 Control. The supplied cable is 16” long. For

locating the ST-EG100-E further from the panel, an optional serial cable may be

ordered directly from SETECH.

Mounting Hole

(Typical for 4.)

RJ45 Network

Jack

DC Power

Connector

DB9 Serial

Male Connector

Figure 1 - SETECH ST-EG100-E Ethernet Gateway Board

3. Connect the female end of the supplied DB9M serial ribbon cable to the male DB9

connector on the ST-EG100-E, and connect the other end of the ribbon cable to an

Elk™ M1™ control board as follows:

• For the M1 Gold control board, connect to female DB9 connector (port 0).

• For the M1EZ8 control board, connect to the female DB9 connector (port 0)

on the M1EZ8MSI Main Serial Port board.

SETECH Security & Automation Revision 1

96-300001 Page 9 of 44

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Sin comentarios

Setech ST-EG100-E Guía de usuario Pagina 9